Great Article from The Fabricator

The fabricator has posted a great article on setting up press brakes.  Here’s an excerpt:

Press brake setup is without argument one of the most difficult tasks any precision sheet metal shop faces. With all of the variables—small variations in material thickness within the same gauge, grain direction, bending methods, tooling choices, and the technician’s skill level, to name just a few—it’s no wonder press brake setup often takes far longer than it should.

Read the full article here:

Bending basics: Streamlining press brake setup

This entry was posted in Press Brake. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

Note: If you are replying to another commenter, click the "Reply to {NAME} ↵" button under their comment!